Table Of Contents

Configure Data Position (G Dataflow)

Version:
    Last Modified: September 27, 2017

    Configures the various ways the data is clocked relative to the Sample clock.

    connector_pane_image
    datatype_icon

    session in

    Instrument session obtained from the Initialize Acquisition Session node, the Initialize Generation Session node, or the Initialize External Calibration node.

    datatype_icon

    channel list

    The channels you want to apply settings to. Leave channel list blank to apply to all channels.

    datatype_icon

    position

    The edge of the Sample clock signal used to time the operation. You can also configure the device to generate data at a configurable delay past each rising edge of the Sample clock.

    spd-note-note
    Note  

    Delay from Sample Clock Rising Edge has more jitter than the rising or falling edge values.

    Name Description
    Sample Clock Rising Edge

    The device samples or generates data on the rising edge of the Sample clock.

    Sample Clock Falling Edge

    The device samples or generates data on the falling edge of the Sample clock.

    Delay from Sample Clock Rising Edge

    The device samples or generates data with a delay from the rising edge of the Sample clock.

    Specify the delay using the delay parameter of the niHSDIO Configure Data Position Delay VI.

    Configuring position with your hardware

    Certain devices have sample clock frequency limitations when a custom delay is used. Refer to the device documentation for more information about these limitations.

    To configure a delay on PXI/PXIe-656X devices, you must delay all channels on the device. NI-HSDIO returns an error if you apply a delay to only a partial channel list.

    datatype_icon

    error in

    Error conditions that occur before this node runs.

    The node responds to this input according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Default: No error

    datatype_icon

    session out

    Handle that identifies the session in all subsequent node calls.

    The session out parameter is obtained from the Initialize Acquisition Session node or the Initialize Generation Session node.

    datatype_icon

    error out

    Error information.

    The node produces this output according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Not supported

    Web Server: Not supported in VIs that run in a web application


    Recently Viewed Topics