Table Of Contents

Configuration

Version:
    Last Modified: September 27, 2017

    Use the Configuration nodes to configure triggers, voltage levels, initial and idle states, data position, generation mode, and other properties for your generation operation.

    node_icon
    Returns the acquired waveform as a two-dimensional array of unsigned 16-bit integers.
    node_icon
    Configures the specified trigger.
    node_icon
    Routes signals (clocks, triggers, and events) to the output terminal you specify. Refer to your device documentation for valid signal destinations.
    node_icon
    Configures the voltage levels for the data, trigger, and event channels. You can use either predefined logic families or custom voltage levels.
    node_icon
    Configures channels for dynamic acquisition (if session in is an acquisition session) or dynamic generation (if session in is a generation session).
    node_icon
    Specifies how many times to generate a waveform or whether it should be continuously generated.
    node_icon
    Sets the state of the channels when the dynamic generation operation is idle. You can specify idle state in either a binary or a string format.
    node_icon
    Sets the initial state for a dynamic generation operation. You can specify the initial state using a string or binary format.
    node_icon
    Selects between acquiring high/low data or valid/invalid data during a static or dynamic acquisition operation.
    node_icon
    Configures the various ways the data is clocked relative to the Sample clock.
    node_icon
    Configures the data position delay with respect to the Sample clock.
    node_icon
    Configures the size of the acquisition, including how many records are acquired and the minimum record size.
    node_icon
    Forces a channel into a high-impedance state. The effect is immediate; it does not require the session be committed.
    node_icon
    Configures the Sample clock. This node allows you to specify the Sample clock source and rate.
    node_icon
    Use the Waveform Control nodes to configure the waveforms in your generation operation.
    node_icon
    Use the Scripting nodes to create and configure scripts for your generation operation.
    node_icon
    Use the Advance Timing nodes to configure advanced timing features.

    Recently Viewed Topics