Table Of Contents

Adjust Calibration (DBL) (G Dataflow)

Version:
Last Modified: September 27, 2017

Performs internal calculations on a single floating point value and saves the resulting values until the end of the External Calibration session.

These values will be stored on the device when Close External Calibration is executed with the action configured to Commit, or discarded if the action is configured as Cancel.

connector_pane_image
datatype_icon

channel

The channel to adjust.

datatype_icon

session in

Instrument handle that identifies your calibration session.

This parameter is obtained from the niHSDIO Initialize External Calibration node

datatype_icon

error in

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error error in contains an error
If no error occurred before the node runs, the node begins execution normally.

If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Default: No error

datatype_icon

value

The floating point value used to perform internal calculations.

datatype_icon

calibration type

The section of the external calibration procedure you are trying to execute.

Refer to the calibration procedure document for your device for the correct value to use.

datatype_icon

calibration reference

Parameter that specifies which internal routing path to configure based on the calibration type.

Refer to the calibration procedure document for your device for the correct value to use.

datatype_icon

session out

Session handle that passes a reference to your calibration session to the next node.

datatype_icon

error out

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error error in contains an error
If no error occurred before the node runs, the node begins execution normally.

If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported

Web Server: Not supported in VIs that run in a web application


Recently Viewed Topics