Table Of Contents

Write Named Waveform (Complex WDT) (G Dataflow)

Last Modified: September 26, 2018

Writes complex waveform data type (WDT) data to the named waveform in onboard memory when the OSP Enabled property is set to True and the Data Processing Mode property is set to Complex.

If streaming is enabled, you can write more data than the allocated waveform size in onboard memory. By default, a call to this node continues writing data from the position of the last sample written.

Programming Patterns

You can change the write position and offset using Set Waveform Next Write Position.

connector_pane_image
datatype_icon

session in

Handle that identifies your instrument session previously allocated by Initialize With Channels.

datatype_icon

channel name

Name of the waveform generator channel that the node uses.

datatype_icon

waveform name

Name of the waveform.

datatype_icon

use waveform dT for IQ rate

Boolean value that specifies whether or not the sample rate or I/Q rate from the specified HWS file should be applied.

True The node applies the sample rate or I/Q rate from the specified HWS file.
False The node does not apply the sample rate or I/Q rate from the specified HWS file.
datatype_icon

waveform

Data you want to use for the arbitrary waveform.

The data must be between -1.0 and +1.0. Use the gain input of Configure Arbitrary Waveform or Configure Arbitrary Sequence to generate different voltages.

datatype_icon

error in

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error error in contains an error
If no error occurred before the node runs, the node begins execution normally.

If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Default: No error

datatype_icon

session out

Reference to your instrument session to wire to the next node.

datatype_icon

waveform name out

Name of the named waveform.

datatype_icon

error out

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error error in contains an error
If no error occurred before the node runs, the node begins execution normally.

If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported

Web Server: Not supported in VIs that run in a web application


Recently Viewed Topics