From 6:00 PM CST Friday, Feb 15th - 2:00 AM CST Sunday, Feb 17th, ni.com will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Table Of Contents

External Calibration Nodes

Last Modified: September 26, 2018

Use the NI-FGEN external calibration nodes to perform external calibration when following the calibration procedure for your waveform generator model.

node_icon
Use the NI-FGEN ADC control nodes only when following the calibration procedure of the waveform generator.
node_icon
Use the NI-FGEN analog output nodes only when following the calibration DC gain and offset portion of the waveform generator calibration procedure.
node_icon
Closes an external calibration session and, if specified, stores the new calibration constants and calibration data, such as time and temperature, in the onboard EEPROM.
node_icon
Use the NI-FGEN external calibration utility nodes to get information about previous calibrations, store information, or password protect the external calibration data on your board.
node_icon
Use the NI-FGEN flatness control nodes only when following the flatness calibration section of the waveform generator calibration procedure.
node_icon
Creates and initializes a special NI-FGEN external calibration session.
node_icon
Use the NI-FGEN VCXO control nodes only when following the oscillator frequency calibration portion of the waveform generator calibration procedure.

Recently Viewed Topics