Table Of Contents

External Calibration Nodes

Version:
    Last Modified: September 16, 2017

    Use the NI-FGEN external calibration nodes to perform external calibration when following the calibration procedure for your waveform generator model.

    node_icon
    Use the NI-FGEN ADC control nodes only when following the calibration procedure of the waveform generator.
    node_icon
    Use the NI-FGEN analog output nodes only when following the calibration DC gain and offset portion of the waveform generator calibration procedure.
    node_icon
    Closes an external calibration session and, if specified, stores the new calibration constants and calibration data, such as time and temperature, in the onboard EEPROM.
    node_icon
    Use the NI-FGEN external calibration utility nodes to get information about previous calibrations, store information, or password protect the external calibration data on your board.
    node_icon
    Use the NI-FGEN flatness control nodes only when following the flatness calibration section of the waveform generator calibration procedure.
    node_icon
    Creates and initializes a special NI-FGEN external calibration session.
    node_icon
    Use the NI-FGEN VCXO control nodes only when following the oscillator frequency calibration portion of the waveform generator calibration procedure.

    Recently Viewed Topics