Table Of Contents

Taking a Measurement

Version:
    Last Modified: May 14, 2018

    This example illustrates how to use the Digital Multimeter (DMM) to measure voltage.

    The procedure for taking other types of measurements is similar. Refer to the Configuration Options (DMM) section to learn about other measurement modes.

    1. Connect the circuit under test to the NI ELVIS III, as shown in the following diagram:

      Refer to Connecting Signals to the Digital Multimeter (DMM) for more details about connecting to the DMM.
    2. Launch the DMM Soft Front Panel (SFP).
    3. Depending on the type of the input signal, select DC voltage or AC voltage for Measurement mode, and select a proper range.
    4. Click Run to start measuring the signal. Read the real-time voltage from the panel. While the instrument is running, you can change the measurement mode and the range by adjusting the settings on the panel.
    spd-note-note
    Note  

    You may hear clicking sounds from the NI ELVIS III while operating the SFP. This is expected behavior and is due to the switching of internal relays.


    Recently Viewed Topics