Table Of Contents

Connecting to the Device via Ethernet

Version:
    Last Modified: May 14, 2018

    Complete the following steps to use an Ethernet cable to connect the NI ELVIS III to your host computer.

    1. Connect the Ethernet cable to the NI ELVIS III as shown in the following figure:
    2. Ensure that the Ethernet cable is connected to a router that is set up correctly.
      spd-note-note
      Note  

      Your host computer and the NI ELVIS III needs to be connected to the same subnet (local network).

    If the connection is successful, you can see the IP address of the Ethernet connection on the OLED display of the NI ELVIS III. Press and hold the user programmable button on the left-hand side of the NI ELVIS III workstation until you turn on the display. The IP address of the Ethernet connection appears after the icon.
    spd-note-tip
    Tip  

    Go to Setting Up the Host Computer next.

    spd-note-tip
    Tip  

    Go to Configuring the Device next.


    Recently Viewed Topics