Table Of Contents

Connecting Signals to Analog Output

Version:
    Last Modified: May 14, 2018

    There are no configuration settings for the analog output channels. All of the analog output channels are single-ended. Each analog output is always referenced to the analog ground (AGND). The following table shows the channel mapping.

    Table 1. Analog Output Signal Mapping
    Application Board Terminals Signal
    Bank A A/AO0 AO 0
    A/AO1 AO 1
    Bank B B/AO0 AO 0
    B/AO1 AO 1
    AGND Analog Ground
    spd-note-notice
    Notice  

    Use AGND for analog signals only.

    Refer to the NI ELVIS III Prototyping Board section on how to access these signals on the NI ELVIS III prototyping board.


    Recently Viewed Topics