Table Of Contents

Configure AC Bandwidth (G Dataflow)

Version:
    Last Modified: September 16, 2017

    Configures frequency properties used for AC measurements.

    This node affects the DMM only when the Function property is set to an AC measurement.

    connector_pane_image
    datatype_icon

    session in

    Instrument identifier from previous NI-DMM nodes.

    Default: None

    datatype_icon

    min frequency

    Minimum expected frequency component of the input signal.

    NI-DMM uses this parameter to calculate the proper aperture for the measurement. NI-DMM sets the Min Frequency property to this value.

    datatype_icon

    max frequency

    Maximum expected frequency component of the input signal.

    NI-DMM uses this parameter only for error checking by verifying that the value of this parameter is less than the maximum frequency of the DMM. NI-DMM sets the Max Frequency property to this value.

    datatype_icon

    error in

    Error conditions that occur before this node runs.

    The node responds to this input according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Default: No error

    datatype_icon

    session out

    Instrument identifier for subsequent NI-DMM nodes.

    datatype_icon

    error out

    Error information.

    The node produces this output according to standard error behavior.

    Standard Error Behavior

    Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

    error in does not contain an error error in contains an error
    If no error occurred before the node runs, the node begins execution normally.

    If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

    If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Not supported

    Web Server: Not supported in VIs that run in a web application

    Hardware Support:

    Valid values for the min frequency and max frequency parameters vary among DMMs. The following table describes the valid ranges for each supported DMM.

    DMM Valid Range
    PXI/PCI/PCIe/USB-4065 10 Hz to 100 kHz
    PXI-4070 1 Hz to 300 kHz
    PXI-4071
    PXI-4072
    PXIe-4080
    PXIe-4081
    PXIe-4082


    Recently Viewed Topics