Table Of Contents

NI-DMM Soft Front Panel and InstrumentStudio

Version:
    Last Modified: May 17, 2018

    When you install NI-DMM on a 64-bit system, you can monitor, control, and record measurements from supported devices using InstrumentStudio. InstrumentStudio is a software-based front panel application that allows you to perform interactive measurements on several different device types in a single program.

    spd-note-note
    Note  

    InstrumentStudio is supported only on 64-bit systems. If you are using a 32-bit system, use your driver's specific soft front panel instead of InstrumentStudio.

    InstrumentStudio is automatically installed when you install the NI-DMM driver. You can access InstrumentStudio in one of the following ways:
    • From the Windows start menu, select National Instruments»[Driver] Soft Front Panel. This launches InstrumentStudio and runs a soft front panel populated with NI-DMM devices.
    • From the Windows start menu, select National Instruments»InstrumentStudio 2018. This launches InstrumentStudio and runs a soft front panel populated with devices detected on your system.
    • From Measurement & Automation Explorer (MAX), select a device and then click Test Panels.... This launches InstrumentStudio and runs a soft front panel for the device you selected.

    For more information on using InstrumentStudio, refer to the InstrumentStudio Manual.


    Recently Viewed Topics