Configure Transducer Type (G Dataflow)

Version:

Configures the transducer type.

session in

Instrument identifier from previous NI-DMM nodes.

Default: None

Transducer Type

Type of device used to measure the temperature.

NI-DMM sets the Transducer Type property to this value. The following table describes the valid values for this parameter.

Value Setting
1 Thermocouple
2 Thermistor
3 2-wire RTD
4 4-wire RTD

Default: 1 (Thermocouple)

error in

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error error in contains an error
If no error occurred before the node runs, the node begins execution normally.

If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Default: No error

error out

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error error in contains an error
If no error occurred before the node runs, the node begins execution normally.

If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.

If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

session out

Instrument identifier for subsequent NI-DMM nodes.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported