From 6:00 PM CST Friday, Feb 15th - 2:00 AM CST Sunday, Feb 17th, ni.com will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Table Of Contents

NI-Digital Pattern Driver Nodes

Last Modified: September 14, 2017

Use the NI-Digital Pattern Driver nodes to run test programs on a digital pattern instrument.

The NI-Digital Pattern Driver nodes are available on the Diagram at the following location: Hardware Interfaces»Electronic Test»NI-Digital

node_icon
Creates and returns a new session to the specified digital pattern instrument to use in all subsequent node calls.
node_icon
Closes the specified instrument session to a digital pattern instrument, aborts pattern execution, and unloads pattern memory.
node_icon
Gets (reads) and/or sets (writes) the niDigital Properties for the NI-Digital Pattern Driver.
node_icon
Use these nodes to configure a digital pattern instrument.
node_icon
Use the Action nodes to perform tasks with a digital pattern instrument.
node_icon
Use the Source and Capture Action nodes to create, configure, write, and fetch source and capture waveforms with the NI-Digital Pattern Driver.
node_icon
Use the Sequencer Flags and Registers nodes to create and configure sequencer flags and registers.
node_icon
Use the Static nodes to program read and write static states for the pin driver.
node_icon
Use the Low Level Action nodes to perform low-level tasks with a digital pattern instrument.
node_icon
Use the PPMU Action nodes to source voltage or current from the PPMU and measure voltage or current from the DUT.
node_icon
Use the Frequency Count nodes to measure frequency.
node_icon
Use the Utility nodes to program NI-Digital Pattern Driver functionality.
node_icon
Use the Calibration nodes to perform a self-calibration or an external calibration on a digital pattern instrument.

Recently Viewed Topics