From 6:00 PM CST Friday, Feb 15th - 2:00 AM CST Sunday, Feb 17th, ni.com will be undergoing system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Table Of Contents

Configuration

Last Modified: September 14, 2017

Use these nodes to configure a digital pattern instrument.

node_icon
Specifies whether digital pattern instrument channels are controlled by the PPMU, Digital, disconnected, or off. Changes take effect immediately.
node_icon
Use the Pin Map nodes to interact with or create pin maps.
node_icon
Use these nodes to configure low-level settings of pin maps and pin groups if you are not loading a pin map file using the niDigital Load Pin Map node.
node_icon
Use the Levels and Timing nodes to configure levels and timing. Levels and timing can be configured through levels and timing sheets or directly through configure node parameters.
node_icon
Use the Levels nodes to program the voltage levels, termination mode, and active load levels on each channel or pin of a digital pattern instrument when not using levels sheets.
node_icon
Use the Time Set nodes to program time sets for a digital pattern instrument when not using timing sheets.
node_icon
TDR
Use these nodes to measure pin propagation delay using Time-Domain Reflectometry (TDR) and to apply delay values to the pins of a digital pattern instrument.
node_icon
Use these nodes to load and unload digital patterns and to specify patterns to burst.
node_icon
Use these nodes to configure triggers.
node_icon
Use the PPMU Configuration nodes to configure the current and voltage levels that the PPMU outputs or measures to the DUT.
node_icon
Use the DC Voltage nodes to change channel settings when the channel is configured for DC voltage.
node_icon
Use the DC Current nodes to change channel settings when the channel is configured for DC current.
node_icon
Use the Frequency Count node to configure measurement time for frequency counters.

Recently Viewed Topics