Transitions the NI-DCPower session from the Running state to the Committed state.
If a sequence is running, the Abort node is stopped.
Instrument session obtained from the Initialize With Channels node.
Error conditions that occur before this node runs.
With the following exception, the node responds to this input according to standard error behavior. This node runs normally even if an error occurred previously. If an error occurred before this node runs, the node passes the error in value to error out, and no errors that occur while this node runs are recorded. If an error occurs while this node runs and no error occurred previously, the node sets its own error status in error out.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.
Default: No error
Handle used to identify the session in all subsequent NI-DCPower node calls.
Error information.
The node produces this output according to standard error behavior.
Standard Error Behavior
Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.
Use the Configure Output Enabled node to disable power output on a per channel basis. Use the Reset node to disable power output on all channels.
Any configuration nodes called after Abort are not applied until the Initiate node is called. If power output is enabled when you call the Abort node, the output channels remain in their current state and continue providing power.
Where This Node Can Run:
Desktop OS: Windows
FPGA: Not supported
Web Server: Not supported in VIs that run in a web application