Waits for the measurement or generation to complete. Use this node to ensure that the specified operation is complete before you stop the task.
task in is the name of the task that the operation applies.
timeout (sec) specifies the maximum amount of time in seconds to wait for the measurement or generation to complete. This node returns an error if the time elapses. The default is 10. If you set timeout (sec) to -1, the node waits indefinitely.
If you set timeout (sec) to 0, the node checks once and returns an error if the measurement or generation is not done.
error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.
task out is a reference to the task after this node runs.
error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.
Where This Node Can Run:
Desktop OS: Windows
FPGA: LabVIEW NXG does not support FPGA devices
Web Server: Not supported in VIs that run in a web application