Adjusts the external calibration constants for an SCXI-1520 module. This module requires reference signals of 0.0 V at gains of 1, 15, 20, and 310 on a particular channel to perform an offset calibration for that channel.
calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.
reference voltage specifies in volts the known voltage to use as a reference for calibration.
measured output specifies in volts the voltage measured at the output of the module.
error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.
calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.
error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.
Where This Node Can Run:
Desktop OS: Windows
FPGA: LabVIEW NXG does not support FPGA devices
Web Server: Not supported in VIs that run in a web application