Creates a custom scale that uses an nth order polynomial equation.
name identifies the custom scale for later use, such as with the DAQmx Create Virtual Channel node.
forward coeff is an array of coefficients for the polynomial that converts pre-scaled values to scaled values. Each element of the array corresponds to a term of the equation.
For example, if index three of the array is 9, the fourth term of the equation is 9x3.
reverse coeff is an array of coefficients for the polynomial that converts scaled values to pre-scaled values. Each element of the array corresponds to a term of the equation.
For example, if index three of the array is 9, the fourth term of the equation is 9y3.
error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.
pre-scaled units is the units of the values to scale.
Units defined by TEDS information associated with the channel.
G. 1 g is approximately equal to 9.81 m/s/s.
Meters per second per second.
Millivolts per volt.
Pounds per square inch.
Volts per volt.
scaled units is the units to use for the scaled value. You can use an arbitrary string. LabVIEW uses the units to label a graph or chart.
scale out is a reference to the custom scale this node creates.
error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.
Where This Node Can Run:
Desktop OS: Windows
FPGA: LabVIEW NXG does not support FPGA devices
Web Server: Not supported in VIs that run in a web application