From 6:00 PM CST Friday, Feb 15th - 2:00 AM CST Sunday, Feb 17th, ni.com will be undergoing system upgrades that may result in temporary service interruption.
We appreciate your patience as we improve our online experience.
Table Of Contents
Full-Bridge Type I
Version:
Last Modified: November 16, 2017
The full-bridge type I configuration only measures the bending strain.
The following figure shows how to position strain gage resistors in a bending configuration for the full-bridge type I.
Full-bridge type I strain gage configurations have the following characteristics:
- Four active strain gage elements, two mounted in the direction of bending strain on the top side of the strain specimen and the other two mounted in the direction of bending strain on the bottom side.
- High sensitivity to bending strain.
- Rejection of axial strain.
- Compensation for temperature.
- Compensation for lead resistance.
- Sensitivity at 1000 µε is ~ 2.0 mVout / VEX input.
Full-Bridge Type I Circuit Diagram
The following symbols apply to the circuit diagram:
- R1 is the active strain gage element measuring compressive strain (–ε).
- R2 is the active strain gage element measuring tensile strain (+ε).
- R3 is the active strain gage element measuring compressive strain (–ε).
- R4 is the active strain gage element measuring tensile strain (+ε).
- VEX is the excitation voltage.
- RL is the lead resistance.
- VCH is the measured voltage.
The following equation converts voltage ratios to strain units for full-bridge type I configurations.
where Vr is the voltage ratio that virtual channels use in the voltage-to-strain conversion equation, and GF is the gage factor.