Gets the resistor level for lines when they are in tristate logic.
dev in is the name as configured in MAX of the device to which this operation applies. A DAQmx device name constant lists all devices installed in the system.
error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.
dev out is the name of the device the operation applied to.
pull up pull down levels is the tristate logic level (either pull up or pull down) for each line.
physical channel is the physical channel that was modified. The DAQmx physical channel constant lists all physical channels for devices installed in the system.
power up state is the pull up pull down level set for the physical channel specified with the physical channel output.
error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.
Where This Node Can Run:
Desktop OS: Windows
FPGA: LabVIEW NXG does not support FPGA devices
Web Server: Not supported in VIs that run in a web application