Table Of Contents

DAQmx Trigger (Start » Analog Window) (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Configures the task to start acquiring or generating samples when an analog signal enters or leaves a range you specify.

    connector_pane_image
    datatype_icon

    task in

    task in is the name of the task that the operation applies.

    datatype_icon

    source

    source is the name of a virtual channel or terminal where there is an analog signal to use as the source of the trigger.

    For E Series devices, if you use a channel name, the channel must be the first channel in the task. The only terminal you can use for E Series devices is PFI0.

    datatype_icon

    window top

    window top is the upper limit of the window. Specify this value in the units of the measurement or generation.

    datatype_icon

    window bottom

    window bottom is the lower limit of the window. Specify this value in the units of the measurement or generation.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    when

    when specifies whether the task starts measuring or generating samples, when the signal enters the window or when it leaves the window. Use window bottom and window top to specify the limits of the window.

    Name Description
    Entering Window

    Start acquiring or generating samples when the signal enters the window.

    Leaving Window

    Start acquiring or generating samples when the signal leaves the window.

    datatype_icon

    task out

    task out is a reference to the task after this node runs.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics