Table Of Contents

DAQmx Setup SCXI Calibration (1540) (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Sets an SCXI-1540 module to the specified gain value for calibration.

    spd-note-note
    Note  

    The terminal where you can measure module output depends on the configuration of the module in MAX. National Instruments recommends cabling the module to the digitizer, so that the output appears on the MCH0± pins of the rear signal connector. Refer to the SCXI-1540 User Manual for more information on the routing of module output.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    physical channel

    physical channel specifies the physical channel to calibrate.

    datatype_icon

    excitation RMS value

    excitation RMS value is the internal AC excitation value in volts RMS.

    datatype_icon

    excitation frequency

    excitation frequency is the internal AC excitation frequency in hertz.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics