Table Of Contents

DAQmx Setup C Series Calibration (9218) (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Sets up external calibration for an NI 9218 device.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    physical channels

    physical channels specifies the name of the physical channel to use to create the virtual channel. The DAQmx physical channel constant lists all physical channels on devices and modules installed in the system.

    You also can wire a string that contains a physical channel to this input. You cannot specify more than one physical channel.

    datatype_icon

    measType

    measType specifies the type of measurement for the device.

    Name Description
    Voltage

    Voltage.

    Current

    Current.

    Bridge

    Wheatstone bridge.

    datatype_icon

    rangeMax

    rangeMax specifies the maximum value in the range, in the units of the measurement type specified by measType. The units for the range inputs should correspond to the measurement type.

    datatype_icon

    rangeMin

    rangeMin specifies the minimum value in the range, in the units of the measurement type specified by measType. The units for the range inputs should correspond to the measurement type.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics