Table Of Contents

DAQmx Setup DSA Calibration (Analog Input » 4480) (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Initializes a PXIe-4480 device for calibrating the specified channel type.

    Refer to the calibration procedure for your device for specific calibration instructions.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    physical channels

    physical channels specifies the physical channel(s) to calibrate.

    datatype_icon

    cal mode

    cal mode specifies the calibration mode for the device.

    Name Description
    Voltage

    Voltage mode.

    Charge

    Charge mode.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics