Table Of Contents

DAQmx Restore Last External Calibration Constants (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Sets the self-calibration constants of the device to the external calibration constants.

    NI sets the external calibration constants at the factory, and those constants remain in effect until you perform a new external calibration on the device.

    This node nullifies any self-calibration you perform on the device. If you have never performed a self-calibration on the device, this node has no effect.

    connector_pane_image
    datatype_icon

    dev in

    dev in is the name as configured in MAX of the device to which this operation applies. A DAQmx device name constant lists all devices installed in the system.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    dev out

    dev out is the name of the device the operation applied to.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics