Table Of Contents

DAQmx Set Power Up States (Digital » Digital Logic Family) (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Sets the digital logic family to use when the device powers up.

    connector_pane_image
    datatype_icon

    dev in

    dev in is the name as configured in MAX of the device to which this operation applies. A DAQmx device name constant lists all devices installed in the system.

    datatype_icon

    logic family

    logic family specifies the logic family to set the device to when it powers up. A logic family corresponds to voltage thresholds that are compatible with a group of voltage standards. Refer to device documentation for information on the logic high and logic low voltages for these logic families.

    Name Description
    2.5 V

    Compatible with CMOS signals.

    3.3 V

    Compatible with LVTTL and LVCMOS signals.

    5.0 V

    Compatible with TTL and CMOS signals.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    dev out

    dev out is the name of the device the operation applied to.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics