Table Of Contents

DAQmx Disconnect Terminals (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Removes signal routes you created by using the DAQmx Connect Terminals node.

    DAQmx Disconnect Terminals cannot remove task-based routes, such as those you create through timing and triggering configuration.

    When this node runs, it immediately removes the route. This type of routing is called immediate routing.

    connector_pane_image
    datatype_icon

    source terminal

    source terminal specifies the originating terminal of the route. A DAQmx terminal constant lists all terminals available on devices installed in the system. You also can specify a source terminal by wiring a string that contains a terminal name.

    datatype_icon

    destination terminal

    destination terminal specifies the receiving terminal of the route. A DAQmx terminal constant provides a list of all terminals available on devices installed in the system. You can also specify a destination terminal by wiring a string that contains a terminal name.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard error in functionality.

    datatype_icon

    error out

    error out contains error information. This output provides standard error out functionality.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics