Creates a custom scale that scales values proportionally from a range of pre-scaled values to a range of scaled values.
name identifies the custom scale for later use, such as with the DAQmx Create Virtual Channel node.
scaled minimum is the smallest value in the range of scaled values. NI-DAQmx maps this value to pre-scaled minimum. Read operations clip samples that are smaller than this value. Write operations generate errors for samples that are smaller than this value.
scaled maximum is the largest value in the range of scaled values. NI-DAQmx maps this value to pre-scaled maximum. Read operations clip samples that are larger than this value. Write operations generate errors for samples that are larger than this value.
error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.
pre-scaled minimum is the smallest value in the range of pre-scaled values. NI-DAQmx maps this value to scaled minimum.
pre-scaled maximum is the largest value in the range of pre-scaled values. NI-DAQmx maps this value to scaled maximum.
pre-scaled units is the units of the values to scale.
Units defined by TEDS information associated with the channel.
G. 1 g is approximately equal to 9.81 m/s/s.
Meters per second per second.
Millivolts per volt.
Pounds per square inch.
Volts per volt.
scaled units is the units to use for the scaled value. You can use an arbitrary string. LabVIEW uses the units to label a graph or chart.
scale out is a reference to the custom scale this node creates.
error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.
Where This Node Can Run:
Desktop OS: Windows
FPGA: LabVIEW NXG does not support FPGA devices