Table Of Contents

DAQmx Connect SC Express Calibration Accessory Channels (G Dataflow)

Last Modified: February 6, 2017

Configures a connection on the SC Express accessory for the specified physical channel(s).

connector_pane_image
datatype_icon

calHandle in

calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

datatype_icon

physical channels

physical channels specifies the names of the SC Express physical channel(s) to use. You can use a list or range of physical channels with this input.

datatype_icon

connection

connection specifies how channels on the SC Express accessory should be configured. The resulting configuration could connect channels to a particular external signal, or some onboard terminal. The supported connections depend on the accessory.

datatype_icon

error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

datatype_icon

calHandle out

calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

datatype_icon

error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices


Recently Viewed Topics