Table Of Contents

DAQmx Perform Bridge Offset Nulling Calibration (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Performs a bridge offset nulling calibration on the channels in the task.

    If the task measures both bridge-based sensors and non-bridge-based sensors, use the channels input to specify the names of the channels that measure bridge-based sensors.

    connector_pane_image
    datatype_icon

    task in

    task in is the name of the task that the operation applies.

    datatype_icon

    channels

    channels is a subset of virtual channels in the task that you want to calibrate. Use this input if you do not want to calibrate all the channels in the task, or if some channels in the task measure non-bridge-based sensors. If the input is empty, this node attempts to calibrate all virtual channels in the task.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    skip unsupported channels

    skip unsupported channels specifies whether or not to skip channels that do not support calibration. If skip unsupported channels is TRUE, this node calibrates only supported channels. If FALSE, this node calibrates the channels specified by channels. The default is FALSE.

    datatype_icon

    task out

    task out is a reference to the task after this node runs.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics