Table Of Contents

DAQmx Adjust SCXI Calibration (153x) (G Dataflow)

Last Modified: February 6, 2017

Adjusts the external calibration constants for an SCXI-1530 or SCXI-1531 module.

connector_pane_image
datatype_icon

calHandle in

calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

datatype_icon

reference voltage

reference voltage specifies in volts the known voltage to use as a reference for calibration.

datatype_icon

measured output

measured output specifies in volts the voltage measured at the output of the module.

datatype_icon

error in

error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

datatype_icon

calHandle out

calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

datatype_icon

error out

error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

Where This Node Can Run:

Desktop OS: Windows

FPGA: LabVIEW NXG does not support FPGA devices


Recently Viewed Topics