Table Of Contents

DAQmx Adjust S-Series Calibration (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Adjusts the external calibration constants for an S Series device. You must connect a known voltage to the device and specify that voltage with reference voltage.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    reference voltage

    reference voltage specifies in volts the known voltage to use as a reference for calibration.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics