Table Of Contents

DAQmx Adjust DSA Calibration (Analog Input » Analog Input With Gain and Coupling) (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Performs external calibration adjustment on a DSA device with the specified gain and coupling configuration.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    reference voltage

    reference voltage specifies in volts the known voltage to use as a reference for calibration. This unit is Vrms for AC coupling or VDC for DC coupling.

    datatype_icon

    gain

    gain specifies the gain setting to calibrate, in decibels.

    datatype_icon

    coupling

    coupling specifies the coupling setting to calibrate.

    Name Description
    AC

    AC coupling.

    DC

    DC coupling.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics