Table Of Contents

DAQmx Adjust SC Express Calibration (4330/1) (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Adjusts the external calibration constants for an NI PXIe-4330 or NI PXIe-4331 device.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    reference voltage

    reference voltage is the voltage across the AI+ and AI- terminals, measured using a DMM.

    datatype_icon

    reference excitation

    reference excitation is the voltage across the EX+ and EX- terminals, measured using a second DMM.

    datatype_icon

    shunt location

    shunt location specifies the resistive leg of the Wheatstone bridge that has an external shunt resistor connected in parallel.

    Name Description
    R3

    R3.

    R4

    R4.

    None

    No shunt resistor connected.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics