Table Of Contents

DAQmx Adjust 4204 Calibration (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Adjusts the internal and external calibration constants for an NI 4204 device. You must connect a known voltage to the device and specify that voltage with reference voltage.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    physical channels

    physical channels specifies the physical channel(s) to calibrate.

    datatype_icon

    lowpass filter cutoff frequency

    lowpass filter cutoff frequency specifies in Hz which lowpass filter cutoff frequency to calibrate.

    datatype_icon

    sample and hold enable

    sample and hold enable specifies whether to calibrate the channel(s) with the sample and hold circuitry of the channel enabled.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    reference voltage

    reference voltage specifies in volts the known voltage to use as a reference for calibration.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics