Table Of Contents

Timebase (G Dataflow)

Version:
    Last Modified: February 6, 2017

    Generates a sine wave of a fixed frequency from the DSA device.

    You must measure the frequency of the generated sine wave and pass that value into the DAQmx Adjust DSA AO Timebase Calibration node.

    connector_pane_image
    datatype_icon

    calHandle in

    calHandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration node.

    datatype_icon

    error in

    error in describes error conditions that occur before this node runs. This input provides standard 'error in' functionality.

    datatype_icon

    calHandle out

    calHandle out is a reference to the calibration session. Wire this output to other external calibration nodes.

    datatype_icon

    expectedFrequency

    expectedFrequency indicates the expected frequency of the sine wave of a calibrated device.

    datatype_icon

    error out

    error out contains error information. If error in indicates that an error occurred before this node ran, error out contains the same error information. Otherwise, error out describes the error status that this node produces.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: LabVIEW NXG does not support FPGA devices


    Recently Viewed Topics