Table Of Contents

Connecting Internal RF Cables

Version:
    Last Modified: October 31, 2019

    1. Connect one end of two 2.4 mm (m)-to-2.4 mm (m) cables to the interior chamber rear bulkhead 1A and 2A ports.
    2. Route the opposite end of the cables through the correct locations on the positioner, as shown in the following figure.
      1. 2.4 mm (m)-to-2.4 mm (m) Cable (x2)
      spd-note-notice
      Notice  

      The internal cables are subject to movement and can interfere with testing if not properly managed.


    Recently Viewed Topics