Table Of Contents

Feedback Node (Reverse) (G Dataflow)

Version:
    Last Modified: March 15, 2017

    Stores data from one execution or loop iteration to the next.

    This node operates similarly to shift registers in loops. The node stores data when the loop completes an iteration and then sends the stored data to the next loop iteration. The next iteration reads the data, writes a new value to the data, and sends it through the loop again. This process continues until the loop completes execution.

    By default, the node stores data from only the previous execution or iteration. However, you can configure the node to store n samples of data by delaying the output of the node for multiple executions or iterations. If you increase Delay to more than one execution or iteration, the node outputs only the initial value until the delay you set is complete. The node then begins to output the stored values in sequential order. The number on the node represents the number of delays you set.

    spd-note-note
    Note  

    The only difference between Feedback Node (Reverse) and Feedback Node (Forward) is that the input and output terminals are reversed. Even though the input and output terminals are reversed, there is no difference in the flow of data.

    connector_pane_image
    datatype_icon

    input

    The data to be stored and sent to the next execution or iteration.

    datatype_icon

    initial value

    The value for the first execution or loop iteration.

    Default: 0

    datatype_icon

    output

    The data stored from the previous execution or iteration.

    Initializing Multiple Iteration Values

    When you set Delay to two or more executions or iterations, you can wire an array to the initial value input to initialize each iteration value. The first element in the array initializes the first iteration value, the second element in the array initializes the second iteration value, and so on.

    Resolving Illegal Cycles

    You can insert a Feedback Node into the cycle to resolve cycle errors.

    Use Search to find and open the following installed examples:
    • Feedback Node – Building an Array
    • Feedback Node – Setting a Delay Value

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: This product does not support FPGA devices


    Recently Viewed Topics