Finds the continuous histogram of a signal.
Representation for the output.
Represents the value of each bin as the number of samples in that bin.
|percent of total||
Represents the value of each bin as a percentage of the total.
Default: sample count
A Boolean to determine initialization of the internal state of the node.
|True||Initializes the internal states to zero.|
|False||Initializes the internal states to the final states from the previous call of this node.|
This node automatically initializes the internal state to zero on the first call and runs continuously until this input is True. For a large data sequence consisting of smaller blocks, when this input is True, this node calculates the histogram of the current block only and ignores previous blocks.
Number of bins in the histogram.
Maximum value to include in the histogram.
Minimum value to include in the histogram.
Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.
Default: No error
The boundary of each bin to handle.
Includes the lower boundary.
Includes the upper boundary.
Determining the Bin Widths When inclusion Is lower
If inclusion is set to lower, the bin widths are determined according to the following equations.
Determining the Bin Widths When inclusion Is upper
If inclusion is set to upper, the bin widths are determined according to the following equations.
The histogram of the input signal.
An array of the center values of the bins of the histogram.
Discrete histogram of the input signal.
Actual number of bins in the histogram.
Actual maximum value in the histogram.
Actual minimum value to include in the histogram.
Error information. The node produces this output according to standard error behavior.
Information about points not falling in any bin upon successful execution of the node.
Total number of values in signal not falling in any bin upon successful execution.
Number of values in signal below the first bin on the lower boundary.
Number of values in signal above the last bin on the upper boundary.
The following illustration shows the waveform of an input signal.
This example configures the node using the following input values:
Where This Node Can Run:
Desktop OS: Windows
FPGA: Not supported