This node operates similarly to shift registers in loops. The node stores data when the loop completes an iteration and then sends the stored data to the next loop iteration. The next iteration reads the data, writes a new value to the data, and sends it through the loop again. This process continues until the loop execution completes.
By default, the node stores data from only the previous execution or iteration. However, you can configure the node to store n samples of data by delaying the output of the node for multiple executions or iterations. If you increase Delay to more than one execution or iteration, the node outputs only the initial value until the delay you specify is complete. The node then begins to output the stored values in subsequent order. The number on the node represents the number of delays you specify.
The data to be stored and sent to the next execution or iteration.
Initial value for the first execution or loop iteration.
If you do not wire a value to initial value, the node uses the default value for the data type.
The data stored from the previous execution or iteration.
Where This Node Can Run:
Desktop OS: Windows
FPGA: Not supported