Wave Generator (Configurable) (G Dataflow)

Type of signal to generate.

Default: Sine Wave

DC offset of the signal.

Default: 0

A Boolean that determines the initial phase of the wave.

Default: False

Amplitude of the signal. The amplitude is also the peak voltage.

Default: 1

Frequency of the signal in Hz.

Default: 10

Initial phase, in degrees, of the signal.

This node ignores phase in if reset phase is False.

Default: 0

Percentage of time a square wave remains high versus low over one period.

square wave duty cycle is valid only if signal type is Square Wave.

Default: 50

Error conditions that occur before this node runs.

The node responds to this input according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error	error in contains an error
If no error occurred before the node runs, the node begins execution normally. If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.	If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.

Default: No error

Sampling rate in samples per second.

Default: 1000

Number of samples in the signal.

samples must be greater than 0. Otherwise, this node returns an error.

This input is available when you configure this node to return a waveform or an array of double-precision, floating-point numbers.

Default: 1000

Timestamp of the output signal. If this input is unwired, this node uses the current time as the timestamp of the output signal.

This input is available only if you configure this node to return a waveform.

Output signal.

This output can return the following data types:

• Waveform
• Double-precision, floating-point number
• 1D array of double-precision, floating-point numbers

Phase of the signal in degrees.

Error information.

The node produces this output according to standard error behavior.

Standard Error Behavior

Many nodes provide an error in input and an error out output so that the node can respond to and communicate errors that occur while code is running. The value of error in specifies whether an error occurred before the node runs. Most nodes respond to values of error in in a standard, predictable way.

error in does not contain an error	error in contains an error
If no error occurred before the node runs, the node begins execution normally. If no error occurs while the node runs, it returns no error. If an error does occur while the node runs, it returns that error information as error out.	If an error occurred before the node runs, the node does not execute. Instead, it returns the error in value as error out.