Table Of Contents

Enable Front End (G Dataflow)

Last Modified: January 9, 2017

Enables the RF front end for the given channel. Use this node to toggle the active ATR state.

Rx Tx ATTR State
disable disable Idle
disable enable Tx only
enable disable Rx only
enable enable Full duplex
connector_pane_image
datatype_icon

error in

Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

Default: No error

datatype_icon

scope

Channel to operate on. Valid options are rx/RF 0, rx/RF 1, tx/RF 0, and tx/RF 1.

datatype_icon

enable

Signal that enables the device front end.

datatype_icon

error out

Error information. The node produces this output according to standard error behavior.

datatype_icon

niUsrpRio Session (out)

The niUsrpRio session used in all subsequent USRP RIO host nodes.

datatype_icon

niUsrpRio Session

The object created by the Open node and used as the session handle for the USRP RIO nodes.

Configuring the Daughterboard

For this node, use the scope parameter to specify which daughterboard to configure.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported


Recently Viewed Topics