Table Of Contents

Advanced Configure LPF (G Dataflow)

Last Modified: January 9, 2017

Updates a specified ATR register state for advanced LO Low Pass Filter configuration.

connector_pane_image
datatype_icon

scope

is the channel to operate on. Valid options are rx/RF 0, rx/RF 1, tx/RF 0, and tx/RF 1. Use this parameter to determine which daughterboard to update the ATR register state of.

datatype_icon

atr register

The specific ATR register to write to. The registers correspond to the four states each daughterboard supports. The daughterboard state is set based on whether Rx and Tx are enabled or disabled, using the Enable Front End node. It is safe to call the Enable Front End node after writing to the ATR registers.

datatype_icon

LO lpf enable

The LO LPF state of the daughterboard.

datatype_icon

error in

Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

Default: No error

datatype_icon

error out

Error information. The node produces this output according to standard error behavior.

datatype_icon

niUsrpRio session

Object created by the Open node and used as the session handle for the USRP RIO nodes.

datatype_icon

niUsrpRio session (out)

The niUsrpRio session used in all subsequent USRP RIO host nodes.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported


Recently Viewed Topics