Table Of Contents

Disconnecting from a VI Running on a Real-Time System

Version:
    Last Modified: April 18, 2016

    When you want to leave a VI running on a real-time system and don't need to communicate with the VI from a host PC, close the project after deploying the VI on the real-time system.

    To complete this task, you need a VI targeted to and running on a real-time system.
    1. To disconnect from a VI, close the project.
    2. When prompted, select Continue to leave the VI running on the real-time system.
      spd-note-note
      Note  

      Any change you make to a VI on the PC after disconnecting from the real-time system causes the host and real-time VI to get out of sync. If the VI is out of sync, you cannot reconnect to the VI running on the real-time system.

    When you need to modify or view the VI running on the real-time system, reconnect to the running VI from the PC. To reconnect, verify that the real-time system is registered, and open the project that contains the running VI. If the VI on the PC is in sync with the VI running on the real-time system, the project automatically reconnects to the running VI.


    Recently Viewed Topics