Table Of Contents

Implementing a Real-Time Application Design

Version:
    Last Modified: April 13, 2016

    Developing an application for a real-time controller is similar to developing an application for a PC. However, real-time applications typically employ particular programming practices in order to adhere to strict timing specifications.

    Before you start implementing a real-time application design, make sure you have a well-planned design. Refer to Designing a Real-Time Application for help designing your application.

    A real-time application is a VI targeted to a real-time controller in SystemDesigner that contains some deterministic code. Real-time VIs contain unique real-time nodes that help you write deterministic code in addition to many of the same nodes that are available in VIs targeted to a PC.

    Complete the following steps to implement your real-time application design.

    1. Create code—To analyze or process data in a real-time application, you must create code on the diagram of a VI targeted to a real-time controller in SystemDesigner. The code you write is entirely dependent on the goals and requirements of your application.
    2. Place deterministic tasks in Timed LoopsTimed Loops execute the code you place within them at a higher priority than code outside of a Timed Loop. You must place code that you want to execute deterministically in a Timed Loop.
    3. Organize deterministic and non-deterministic tasks—Separating deterministic code from non-deterministic code helps ensure that deterministic tasks reserve enough processor resources and avoid excessive jitter.
    4. Transfer data within, to, and from a real-time application—Real-time applications typically require communication between loops or subVIs within the real-time application and with other applications running on a PC or FPGA. You can use data communication nodes to transfer data within, to, and from a real-time application.
    5. Eliminate common sources of jitter—You can introduce jitter into your application in a variety of ways. However, you can follow a few simple strategies to identify and eliminate the more common sources of jitter.
    After you finish implementing your application design, you can deploy and test your application.

    Recently Viewed Topics