Table Of Contents

Pattern Generator (Sine) (G Dataflow)

Version:
    Last Modified: January 9, 2017

    Generates a signal containing a sine pattern.

    connector_pane_image
    datatype_icon

    amplitude

    Amplitude of the pattern.

    Default: 1

    datatype_icon

    cycles

    Number of complete periods of the sine pattern.

    spd-note-note
    Note  

    Because this input is a floating-point number, fractional cycles are possible for the sine pattern. Furthermore, setting this input to a negative number does not generate an error condition because it is mathematically correct and useful to consider negative frequencies in Fourier and spectral analysis.

    Default: 1

    datatype_icon

    phase

    Phase, in degrees, of the sine wave without reset. This input must be in degrees rather than radians. If this input is in radians, convert the value to degrees before using this node.

    Default: 0

    datatype_icon

    error in

    Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

    Default: No error

    datatype_icon

    samples

    Number of samples in the pattern. This input must be greater than or equal to 0. If this input is less than zero, the node sets the output pattern to an empty array and returns an error.

    Default: 128

    datatype_icon

    sine pattern

    Output sine pattern. The largest output pattern this node can generate depends on the amount of memory in your system and is theoretically limited to 2,147,483,647 (231 - 1) elements.

    datatype_icon

    error out

    Error information. The node produces this output according to standard error behavior.

    Where This Node Can Run:

    Desktop OS: Windows

    FPGA: Not supported


    Recently Viewed Topics