Table Of Contents

MT Resample (Complex Cluster) (G Dataflow)

Last Modified: January 9, 2017

Returns a complex-valued waveform and resamples and/or realigns the waveform based on the input parameters that you specify.

connector_pane_image
datatype_icon

input complex waveform

The complex baseband waveform data.

datatype_icon

t0

The trigger (start) time of the Y array.

Default: 0.0

datatype_icon

dt

Time interval between data points in the Y array.

Default: 1.0

datatype_icon

Y

The complex-valued time-domain data array. The real and imaginary parts of this complex data array correspond to the in-phase (I) and quadrature-phase (Q) data, respectively.

datatype_icon

desired sample rate

The desired sample rate of the output complex waveform data, in hertz (Hz). This value can be an integer or a non-integer multiple of the input data sample rate.

Default: 1.00

datatype_icon

error in

Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

Default: no error

datatype_icon

reset?

A Boolean that determines whether the node continues to resample using the previous iteration states.

TRUE The node resets the previous iteration states and restarts fractional resampling.
FALSE The node continues to resample using the previous iteration states.

Default: TRUE

datatype_icon

flush buffers?

A Boolean that determines whether the node forces out samples that are delayed because of the FIR filters used in the resampling algorithm. Set this parameter to TRUE during single-shot operations or during the last iteration of continuous operations.

TRUE The node forces out samples that are delayed because of the FIR filters used in the resampling algorithm. The node destroys the internal states of the algorithms and you cannot perform continuous processing on the signal during subsequent iterations. If you set the flush buffers? parameter to TRUE, you must set the reset? parameter to TRUE on the subsequent iteration.
FALSE The node does not force out samples that are delayed because of the FIR filters used in the resampling algorithm.

Default: FALSE

datatype_icon

initial sample offset

The initial sample offset, in seconds. This positive value specifies the location in time of the first output point relative to the first input point.

Default: 0.00

datatype_icon

output complex waveform

The resampled complex baseband waveform data.

datatype_icon

t0

The trigger (start) time of the first value in the Y array.

Default: 0.0

datatype_icon

dt

Time interval between data points in the Y array.

Default: 1.0

datatype_icon

Y

The complex-valued time-domain data array. The real and imaginary parts of this complex data array correspond to the in-phase (I) and quadrature-phase (Q) data, respectively.

datatype_icon

error out

Error information. The node produces this output according to standard error behavior.

Waveform Realignment

To realign the input waveform in time, specify a non-zero value to the initial sample offset parameter. Positive offset values push the output complex waveform forward relative to the input complex waveform. Negative offset values are invalid.

Waveform Resampling

To resample a waveform, specify a desired sample rate that differs from the existing sample rate of the input complex waveform. To realign a waveform without changing its sample rate, specify a value for the desired sample rate parameter equal to the existing sample rate. To resample a waveform without changing the relative timing offset between the input and output complex waveforms, set the initial sample offset parameter to 0.

Waveform Downsampling

To downsample a waveform, ensure that the input signal is strictly bandlimited and follows the Nyquist criterion for the final sample rate. You can ensure this by low-pass filtering the input signal.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported


Recently Viewed Topics