Table Of Contents

MT Modulate PM (G Dataflow)

Last Modified: January 9, 2017

Performs phase modulation (PM) on an RF carrier wave according to the baseband information signal specified by the message signal parameter. This node performs signal processing on data and operates independently of your hardware settings. You can use this node in both simulated and hardware-equipped applications.

connector_pane_image
datatype_icon

message signal

Message signal used to modulate the carrier wave.

datatype_icon

phase deviation

The maximum desired phase deviation, in degrees, of the phase-modulated signal returned in the PM modulated waveform parameter.

Default: 1 degree

datatype_icon

error in

Error conditions that occur before this node runs. The node responds to this input according to standard error behavior.

Default: no error

datatype_icon

PM modulated waveform

The baseband signal data and the complex envelope of the phase-modulated signal.

datatype_icon

t0

The trigger (start) time of the signal data.

datatype_icon

dt

Time interval between data points in the signal data.

datatype_icon

Y

The complex-valued time-domain data array. The real and imaginary parts of this complex data array correspond to the in-phase (I) and quadrature-phase (Q) data, respectively.

datatype_icon

error out

Error information. The node produces this output according to standard error behavior.

Phase-Modulated Wave Formula

The output phase-modulated wave is described by the equation:

P M = e i ( 2 π p h a s e D e v i a t i o n 360 ( m e s s a g e S i g n a l ) + ( c a r r i e r P h a s e ) )

This node sets carrierPhase in the preceding equation to 0. To adjust the carrier phase, use the initial phase parameter of MT Upconvert Baseband (Real) or MT Upconvert Baseband (Complex).

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported


Recently Viewed Topics