Table Of Contents

Configuring Adapter Module Settings through the CLIP

Last Modified: May 2, 2016

You can configure settings such as clocking, ADC, DAC, sampling, attenuators, and filters on your NI FlexRIO adapter modules using I/O signals available in the CLIP.

  1. Use the User Command, User Data 0, and User Data 1 signals to configure these settings. Refer to the User Command reference for your CLIP for information about which settings you can configure and values to use to configure those settings.
  2. Use the User Command Commit signal to apply these settings.
  3. Use the User Command Status signal to determine whether the previous command was expected successfully. If the command was not executed successfully, use the User Error signal to determine if you must reinitialize the device due to an error.

Recently Viewed Topics