Table Of Contents

ni579x Send FAM Register Operations (G Dataflow)

Last Modified: January 9, 2017

Sends the FAM register operations using the register bus.

connector_pane_image
datatype_icon

scope

Ignored.

datatype_icon

Register Bus

Register Bus object created by ni579x Open and used as the session handle for the NI-579x Configuration nodes.

datatype_icon

FAM Register Operations

Use this node to address registers within a specific device.

For example, to write to register 0 × 25 on the ADC, set the Register Bus Address to 0×01000025.

FAM Register Offset specifies the register to be written to. Valid values:

  • ADC
  • DAC
  • Clock Distribution Chip
  • Frequency/Phase Adjust DAC
  • EEPROM
  • EEPROM Commands
  • LO1
  • Rx Atten Pre-LNA
  • Rx Atten Post-LNA
  • Tx Atten
  • Other

Address– use the Address offsets to address registers within a specific device.

Write(T)/Read (F)– specify True to write to the register address, and specify False to read from the register address.

Write Data– specifies the number of times to write the data.

datatype_icon

Error In

Error conditions that occur before this node runs. Use this information to decide whether to bypass any functionality if this node receives errors from other nodes.

datatype_icon

Register Bus (out)

The Register Bus object created by ni579x Open and used as the session handle for the NI-579x Configuration nodes.

datatype_icon

FAM Register Read Data

Returns the FAM Register data.

datatype_icon

Error Out

Information about errors or warnings that occurred during or before the execution of this node.

Where This Node Can Run:

Desktop OS: Windows

FPGA: Not supported


Recently Viewed Topics